Advertisement
Read all the following information and instructions prior to installing & operating the Strainer. Failure
to comply with these instructions could result in bodily injury or property damage.
PAGE 1
Model 53 BTX Duplex Strainer, Sizes
Model 53 BTX Duplex Strainer, Sizes
Seal Too
Extractor Tool l
IOM53CART Rev.1 June 2010
Cartridge Maintenance
Parts List for Eaton Model 53 BTX
Item
Description
1.
Duplex Strainer Body
2.
Strainer Basket (2) *
3.
Basket Cover (2)
4.
Cartridge
5.
Stud (4)
6.
Eye Nut (4)
7.
Pipe Plug (2)
8.
Pipe Plug (3)
9.
Pipe Plug (2)
10.
O-Ring, Cover (2) *
11.
Stem Retainer
12.
Cap Screw
13.
Cap Screw (4)
14.
Cap Screw
15.
Vent Valve
16.
Pin
17.
Handle
18.
Cap Screw
19.
Washer
20.
O-Ring, Stem (4) *
21.
O-Ring, Cartridge (2) *
22.
Seal (4) *
23.
Seat (4) *
24.
Ball (2)
25.
Stem, Top
26.
Stem, Middle
* Recommended Spare Parts List
Item
Description
2
Strainer Basket (2)
10
O-Ring, Cover (2)
20**
O-Ring, Cover (4)
21**
O-Ring, Cartridge (2)
22**
Seal (4)
23**
Seat (4)
** Only supplied in a "#53 Sealing Kit"
3
3
⁄
⁄
" - 4"
" - 4"
4
4
Filtration.Eaton.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Eaton 53 BTX
Summary of Contents for Eaton 53 BTX
- Page 1 ” - 4” Read all the following information and instructions prior to installing & operating the Strainer. Failure to comply with these instructions could result in bodily injury or property damage. Parts List for Eaton Model 53 BTX Item Description...
- Page 2 Cartridge Maintenance Model 53 BTX Duplex Strainer, Sizes ⁄ ” - 4” CARTRIDGE MAINTENANCE Lower seals, seats and ball remain in place with the handle positioned over the inlet. Do not IMPORTANT remove any of these components at this time.
- Page 3 Cartridge Maintenance Model 53 BTX Duplex Strainer, Sizes ⁄ ” - 4” 22. Stand the cartridge up with top up and inlet facing assembler. Ensure that the middle stem, Item 26 is equally spaced between Check for alignment. upper and lower ball bores of the cartridge. IMPORTANT Ensure that both middle stem O-rings, Item 20 are compressed Inside diameters of balls are to be aligned into the cartridge middle stem bore. with inside diameter of seats.
- Page 4 Shanghai, P .R. China our control, no guarantee, expressed or implied, is made by Eaton as to the e ects of such use or the results to be obtained. Eaton assumes no liability arising out of the use by others of such products. Nor...
Need help?
Do you have a question about the 53 BTX and is the answer not in the manual?
Questions and answers