Table of Contents
Advertisement
Section 6: ASSEMBLY AND SET-UP
6.1
Platter assembly
1. Insert platter to center spindle
2. Stick the lower "mirror mat" (2) on the platter with 4 small pcs 2x2 cm of double sided adhesive tape.
2. Also stick the platter weight on "mirror mat" at the same way.
3. Stick the upper "mirror mat" (1) on the platter weight with 4 small pcs 2x2 cm of double sided adhesive
tape
4. Remove the protective sheet of blank disc on the top side, and push the blank disc down on the mirror
mat (1) using a lint-free cloth or the included record cleaner. Apply sufficient pressure to firmly secure
the vinyl blank to the mirror mat.
5. Put on the disc holder to secure the blank vinyl.
•
If the blank disc is not dust-free, it may create skipping or noise problems. Ensure your blank is
perfectly clean.
•
If the blank disc is not secured to mirror mat, slipping may occur which will render your final cut
unusable.
6.2 Ioniser Assembly
Secure ioniser with 2 screws as per picture below.
(Figure 10.2-A)
FIG10.2-A
6.3 Tracking arm/counter weight assembly
Assemble counter weight on the rear of tracking arm.
(Figure 10.3-A)
FIG10.3-A
11
Advertisement
Table of Contents
