Assembly And Set-Up - Vestax PDX-a2S Owner's Manual

ASSEMBLY AND SET-UP

Installation of Turntable Platter
○
1 By placing the turntable platter on the center spindle, the platter
adjusts to match the spindle by itself.
○
2 Place the slip mat on the platter.
○
3 Extra care should be taken to avoid damaging magnet by
dropping it.
N O T E
Never connect the AC power plug before assembly has
been completed.
Installation of Balance Weight
○ 1
Place the balance weight on the rear shaft of the tone-arm
winding the balance weight clockwise.
Method of Using Slip Mat
○ 1
Place slip mat on the turntable platter, and place the record on
the slip mat. It is possible to stop and return the record by hand
while the turntable revolving.
Installation of Cartridge
○
1
In accordance with the instructions of the cartridge, install a
cartridge properly.
○
2 Connect the lead wires to the cartridge terminals. The terminals
of most cartridges are color corded. Connect each lead wire to
the terminal of the same color.
R e d (R+) Right Channel+
White (L-) L e f t Channel+
N O T E
In case the cartridge weight is less than 8g, it is
necessary to fix the attached shell weight on the
cartridge.
Green (R-) Right Channel -
B l u e (L-) L e f t Channel -
NUT
SHELL
SHELL WEIGHT
CARTRIDGE
STYLUS
SCREWS
6
Surface of slip mat (printed): Disk side
Inside of slip mat : Slip side
LEAD WIRE
TERMINAL