Advertisement
REPLACEMENT PARTS
REF.
DESCRIPTION
MANUAL CRANK
A
(INCLUDES BRAKE RELEASE HANDLE)
B
ADJUSTABLE LEG WITH FOOT PAD
C
30 AMP MANUAL RESET CIRCUIT BREAKER
D
3/8" SAFETY LOCK PIN
E
UNIVERSAL CONNECTOR STORAGE KIT
MAINTENANCE
Due to the design of the Husky
low-friction ball screw, the inner assembly of the jack
does not require regular lubrication. But to keep your
jack in good, functional condition, fully extend the jack
and clean the inner jack tube once per year. After
cleaning, coat the tube with a light grease or silicone
spray lubricant.
TROUBLESHOOTING
CAUSE
SOLUTION
Open Internal
Wait 15 seconds for breaker to close.
Circuit Breaker
Open Manual
Reset the breaker by pressing the button on
Reset Circuit
the breaker.
Breaker
Check the connection between the negative
terminal on the battery and the vehicle, since
the jack is grounded to the vehicle chassis
through the star washers on the coupler.
Poor Ground
Ensure the mounting hardware (bolts,
washers, and star washers) are in good
condition.
Check battery & electrical connections.
Power supplied must be at least 10 Volt DC.
No or Low
If the battery is low, plug the trailer cable
Voltage
into the tow vehicle, and start the tow vehicle
to provide power to the jack.
PROBLEM:
Crank handle will not turn during manual operation
CAUSE
SOLUTION
Disengage the brake by installing the brake
Engaged Brake
release handle on the brake lever and pulling
forward.
©2023 Keystone Automotive Operations Inc. All Rights Reserved. September 2023. REV1
PART#
87639
87461
87526
32335
81497
Super Brute's
®
See www.huskytow.com for Warranty Information / Tech Support / Product Updates.
Figure 4
E
B
C
A
D
Page 5 of 7
Advertisement
