Table of Contents
Advertisement
Resetting
the date
and time
The dock is set to East Coast Standard Time at the factory.
The date and time are held in memory by the lithium battery. If you replace the lithium
battery with the battery pack or other power source connected, you need not reset the
date and time.
You must reset the date and time when the lithium battery becomes dead with no
power source installed.
First, set the year, then the month, the day, the hour and then the minute.
(1) While the camcorder is in the standby mode, press MENU to display the
MENU settings.
(2) Turn the SEL/PUSH
EXEC dial to select _b, then press the dial.
(3) Turn the SEL/PUSH
EXEC dial to select CLOCK SET, then press the dial.
(4) Turn the SEL/PUSH
EXEC dial to adjust the desired year, then press the dial.
(5) Set the month, day and hour by turning
the SEL/PUSH
EXEC dial and
pressing the dial.
(6) Set the minute by turning the SEL/PUSH
EXEC dial and pressing
the dial by
the time signal. The clock starts to move.
(7) Press MENU to make the MENU settJ.ngs disappear. The time indicator
appears. Press TIME to make the time indicator disappear.
_o
_TE
W
12:00_0_U
I
_
_
•
I_ENU_
:END
I_ENUI
:END
I
o
E:
.<
0
€
..........
o .......
LT_ SIZE
l
i_
LT_ S_ZE
57
Advertisement
Table of Contents
