Table of Contents
Advertisement
Connecting Other Equipment
<>: Signal flow
(Front inner panel)
Connecting two VCRs (not equipped with an S video output jack) for tape editing
(Rear of projection TV)
VCR
(for playback)
to video
to audio
output
output
VMC-810S/820S
(not supplied)
Preparing for use
1 Turn on the projection TV.
2 Press TV/VIDEO on the projection TV or on the Remote
Commander so that "VIDEO 1 " "VIDEO 2" or "VIDEO 3"
appears on the screen.
VIDEO 1: for equipment connected to VIDEO 1 IN
VIDEO 2: for equipment connected to VIDEO 2 IN
VIDEO 3: for equipment connected to VIDEO 3 IN
Notes
© If you try to use equipment that is connected to the front and rear
VIDEO 3 IN jacks at the same time, the picture will be distorted.
Be sure you tum off one piece of ecuipment first.
¢ {f you have connected to a Camcorifer's input jacks, do not
connect to the projection TV's input jacks.
If you connect equipment to the rear VIDEO 3 IN S VIDEO jack,
you cannot receive the output signal from the VIDEO 3 OUT
VIDEO jack.
18
| Chapter 1: Setting Up
VMC-810S/820S
(not supplied)
Watching a different image while duplicating
The VIDEO 3 OUT jacks only output the signal from the
VIDEO 3 input jacks.
If you connect a VCR for playback to the front or rear
VIDEO 3 IN jacks, and a VCR for recording to the VIDEO 3
OUT jacks to duplicate your recorded tapes, you can watch
input images different from the image being output for
recording.
To watch a different input image
Press TV/VIDEO on the projection TV or on the Remote
Commander to select the input image you want to watch.
Advertisement
Table of Contents
