Ballard Designs LO472 Manual

Solar outdoor lantern

Advertisement

Quick Links

PRODUCT NAME: Solar Outdoor Lantern
ITEM NUMBER: LO472
ASSEMBLED DIMENSIONS: 14" H x 10" Diameter or 10"H x 10" Diameter

IMPORTANT SAFETY INSTRUCTIONS:

-For your safety, please completely read Instruction Sheet before using lamp.
-Keep product out of reach of children.
-Do not remove screws or open lamp.
-Do not leave lamp outside in heavy rain. Protect from excessive moisture.
-Charge lamp in direct sunlight (Lamp must be OFF) or use DC-USB (included).
-Disconnect from charger when not in use.
-Do not drop or place heavy objects on lamp.
-Do not use lamp if cracked or broken.

WARNING:

-Built-in rechargeable battery is not replaceable.
-Do not remove or replace battery.
-Do not dispose lamp into trash. Refer to local regulations for proper disposal.
-Battery should be fully discharged before disposal.
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 12-20-2022
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA
Page 1 of 3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LO472 and is the answer not in the manual?

Questions and answers

Summary of Contents for Ballard Designs LO472

  • Page 1 Customer Service: 800-367-2810 Online: www.ballarddesigns.com PRODUCT NAME: Solar Outdoor Lantern ITEM NUMBER: LO472 ASSEMBLED DIMENSIONS: 14” H x 10” Diameter or 10”H x 10” Diameter IMPORTANT SAFETY INSTRUCTIONS: -For your safety, please completely read Instruction Sheet before using lamp. -Keep product out of reach of children.
  • Page 2 ENVIRONMENTAL PROTECTION: The symbol on the product dictates that Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. PARTS Check to make sure you have the following: INCLUDED: 1- DC - USB Cord (B) 1- Light (A)
  • Page 3 STEP 1: INSTALL CABLE AND CHARGE LAMP - Connect USB Cable to a computer or any 5V OUTPUT USB charging unit. - Insert other end of Cable into DC port on Lamp (A) - Charge for 5-6 hours (or until fully charged) prior to use. - Indicator light is RED during CHARGING and GOES OUT when CHARGING IS COMPLETE.

Table of Contents