Ballard Designs VERANO 3 Installation Instructions

Light outdoor wall sconce

Download this manual

PRODUCT NAME: VERANO 3 LIGHT OUTDOOR WALL SCONCE

ITEM NUMBER: LO410 3

DIMENSIONS OF ITEM ASSEMBLED:

IMPORTANT SAFETY INSTRUCTIONS:

-We strongly recommend that a professional electrician install all direct wire fixtures.

-These Assembly Instructions are provided for your safety. It is important that they are read carefully

and completely before assembling this Fixture.

-This product must be installed with the applicable installation code by a person familiar with the

construction and operation of the product.

-This Fixture has been rated for up to 60 Watt MAX Type B Candelabra Bulb (NOT Included).

-Before starting installation of this Fixture or the removal of a previous fixture, disconnect the power

by turning off the circuit breaker or removing the fuse from the fuse box.

WARNING:

-Deviation from the Assembly Instructions may result in a risk of fire or electric shock.

-To reduce risk of fire, electrical shock, or personal injury, always turn off and unplug Fixture and

allow it to cool prior to replacing the bulb.

-Do not touch the bulb when the Fixture is turned on. Do not look directly at the lit bulb.

-Keep flammable material away from the lit bulb.

PRODUCTS ARE NOT INTENDED

FOR COMMERCIAL USE.

10"W x 18.5"H x 12" E

Customer Service: 800-367-2810

Online: www.ballarddesigns.com

MADE IN CHINA

Page 1 of 4

Need help?

Do you have a question about the VERANO 3 and is the answer not in the manual?

Page 1 Customer Service: 800-367-2810 Online: www.ballarddesigns.com PRODUCT NAME: VERANO 3 LIGHT OUTDOOR WALL SCONCE ITEM NUMBER: LO410 3 DIMENSIONS OF ITEM ASSEMBLED: 10”W x 18.5”H x 12” E IMPORTANT SAFETY INSTRUCTIONS: -We strongly recommend that a professional electrician install all direct wire fixtures.
Page 2 NOTE: Remove all parts and hardware from the box along with any plastic protective packaging and carefully lay all the parts out on a clean, flat surface. DO NOT discard any contents until after assembly and installation is complete to avoid accidently discarding small parts or hardware.
Page 3 NOTE: Before starting installation of this Fixture or the removal of a previous Fixture, disconnect the power by turning off the circuit breaker or removing the fuse from the fuse box. STEP 1: Attach the Mounting Strap (C) to the Outlet Box using the Outlet Box Mounting Screws (B).
Page 4 NOTE: Before starting installation of this Fixture or the removal of a previous Fixture, disconnect the power by turning off the circuit breaker or removing the fuse from the fuse box. STEP 3: Attach the Fixture Body (A) to the Mounting Plate (C) by screwing on the Ball nut (E).

Lo410 3