Ballard Designs Ada LL376 Assembly Instructions

Enamel floor lamp

PRODUCT NAME: A

ITEM NUMBER: LL37

ASSEMBLED DIMENSIONS:

IMPORTANT SAFETY INSTRUCTIONS:

-This Lamp has a polarized plug (one blade is wider than the other) as a feature to reduce the risk

of electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fully fit in

the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an

extension cord unless plug can be fully inserted. Do not alter the plug.

-For your safety, please read instructions carefully and completely before beginning assembly

or installation.

-Product must be installed according to applicable code(s) by a person familiar with its construction

and operation.

-This Lamp socket rated up to 100 Watt MAX Type A Bulb (not included). LED recommended.

WARNING:

-Deviation from assembly instructions may cause risk of fire or electric shock.

-To reduce risk of personal injury, always turn off fixture and allow bulb to cool prior to

replacement.

-Do not touch or look directly at illuminated bulb.

-Keep flammable material away from illuminated bulb.

PRODUCTS ARE NOT INTENDED

FOR COMMERCIAL USE.

UPDATED:

10-25-2022

Floor Lamp

"H x 18"W x

Customer Service: 800-367-2810

Online: www.ballarddesigns.com

MADE IN CHINA

Page 1 of 3

Table of Contents

Do you have a question about the Ada LL376 and is the answer not in the manual?

Page 1 Customer Service: 800-367-2810 Online: www.ballarddesigns.com PRODUCT NAME: A Floor Lamp ITEM NUMBER: LL37 ASSEMBLED DIMENSIONS: ”H x 18”W x ”D IMPORTANT SAFETY INSTRUCTIONS: -This Lamp has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of electric shock.
Page 2 Unplug lamp prior to installation or removal. Remove all parts, hardware and protective packaging from carton and carefully arrange on a clean, level surface. Prevent accidentally discarding small parts or hardware. Retain all carton contents until assembly and installation are complete. Approved Location for Use: Dry Indoor Environment Assembly Time: 10 Minutes HARDWARE AND COMPONENTS...
Page 3 Unplug lamp prior to installation or removal. STEP 1: Carefully arrange, turn and tighten Fixture Body (A) to Stem (B) and Base (C). Pull excess cord through Base. STEP 2: Prepare then adhere Base Pad (E) onto underside of Base (C). Do not twist lamp cord while turning these pieces together.