Connecting The Tool - Makita VC012G Instruction Manual

NOTE: You can change the suction power before
turning on the cleaner.
NOTE: The cleaner starts the operation with the
same suction power as the last operation.
NOTE: If you remove the battery immediately after
turning off the appliance, while the motor is rotating,
the cleaner may not start the operation with the same
suction power as the last operation.
Hose band
Hose band can be used for holding the hose or flexible
rubber nozzle.
To secure the hose to the vacuum cleaner body, pass
the hose band through the slot on the body. You can
attach the hose band on either side.
1
2
Fig.11
► 1 . Hose band 2. Slot 3. Hose
The loops on the lower belt can be used for carrying
cuffs as illustrated.
2
1
Fig.12
► 1 . Loop 2. Cuff
ASSEMBLY
CAUTION:
Always be sure that the appli-
ance is switched off and the battery cartridge
is removed before carrying out any work on the
appliance.
3
2
1
10 ENGLISH
Assembling hose
Insert the hose cuff into the vacuum cleaner body and
turn it clockwise.
Fig.13 Fig.13
► 1 . Hose cuff 2. Vacuum cleaner body

Connecting the tool

If the bent pipe assembly is attached to the hose,
loosen the sleeve of bent pipe assembly and remove it.
1
Fig.14
► 1 . Hose 2. Bent pipe assembly 3. Sleeve
1. Attach the front cuff to the hose for dust extraction.
When connecting the front cuff, make sure that it is
securely screwed on the hose.
2. Connect the front cuff to the tool's extraction
outlet.
3
Fig.15
► 1 . Front cuff 2. Extraction outlet 3. Hose
1
2
2
3
1
2