Adjusting Cutting Height - Scag Power Equipment SFC-21-4GX Operator's Manual

R

4.13 ADJUSTING CUTTING HEIGHT

The mower deck can be adjusted from a height of 1-1/2
inches to 4-1/2 inches at 1/2-inch intervals. To adjust the
cutting height:
WARNING
DO NOT adjust the cutting height with the mower
blade rotating. Disengage the power to the cutter
blades and then adjust cutting height.
1. Disengage the power to the cutter blade.
2. Apply the park brake.
3. Lift up and forward on the cutting height adjustment
levers at all four (4) locations. See Figure 4-5.
4. Stop each lever on the cutting height index at the
desired cutting height. See Figure 4-5. All four (4)
levers should be set at the same cutting height.
CUTTING HEIGHT
ADJUSTMENT LEVER
Figure 4-5. Adjusting Cutting Height
18
Section 4
CUTTING HEIGHT
ADJUSTMENT LEVER