Operation Considerations - Scag Power Equipment SFC-21-4GX Operator's Manual

R
TEST NOT USING THE GRASS BAG
1. Remove the grass bag.
2. Install the rear discharge plug.
3. Move the machine onto a paved surface such as
a driveway, sidewalk, parking lot or patio next to a
section of grass.
4. Position the machine next to a patch of grass and
approximately 3" away. See Figure 2-1.
5. Start the engine. Allow the engine to warm up before
engaging the blade.
6. Engage the blade.
-NOTE-
The grass next to the the machine should start to
move from the air flow, indicating that the blade
is rotating.
Figure 2-1. Blade Stop
3"
3"
7. Watch the grass and release the control bar.
8. Immediately start counting out 3 seconds and watch
for the grass to stop moving.
If the grass does not stop moving within 3 seconds
of releasing the control bar, the blade stop system
could be deteriorating or out of adjustment. Contact
your local Authorized Scag Power Equipment
Dealer immediately to have the blade stop system
repaired.
9. Shut the engine off and wait for all moving parts to
stop.

2.5 OPERATION CONSIDERATIONS

1. Know the function of all controls and how to stop
quickly.
WARNING
DO NOT operate on steep slopes. ALWAYS
FOLLOW OSHA APPROVED OPERATION.
2. Reduce speed and exercise extreme caution on
slopes and in sharp turns to prevent tipping or loss
of control. Be especially cautious when changing
directions on slopes.
3. Do not mow or operate on excessively steep slopes.
Poor footing could cause a slip and fall accident.
4. To prevent tipping or loss of control, start and stop
smoothly, avoid unnecessary turns and travel at
reduced speed.
5. Immediately stop the machine if you lose drive
control while operating. Inspect the machine and
correct the problem before continuing to operate.
6. When using any attachment, never direct the
discharge of material toward bystanders or allow
anyone near the machine while in operation.
7. Start the engine when the blade control bar is in
the neutral lock position, and the drive control bar is
disengaged.
8. If the mower discharge ever plugs, shut off the
engine, remove the spark plug wire, and wait for all
movement to stop before removing the obstruction.
6
Section 2
-NOTE-