Samsung VR20T6001M Series Quick Manual page 5

How to use & charge
Please charge the product fully before
the first operation.
Caution
When charging the battery, the button
on the main unit and the remote control
will not work.
Only use authorized adapter. Or, it may
cause serious damage to the product.
Do not charge the non-rechargeable
batteries.
1 Wet mops thoroughly with
clean water, then wring water
out.
* We recommend you wash the
mops with detergent before
first time use.
4 Close the rubber cap of the
water supply mop kit and
attach to the bottom of the
main unit. (Pressing down
while gently turning side to
side. You will hear a click when
they attach.)
Yellow LED Blinks
Low battery level
2 Attach the mop pads to the
water supply mop kit. (See the
figure below.)
Correct
Wrong
5 Press the Operation button for
2 seconds until it beeps and
light stays on, and then start
cleaning.
Remove the protective film from the
product before use.
Blue LED Blinks
Medium battery level
3 Open the rubber cap of the
water supply mop kit and fill it
with clean water.
* Using the product without
water in the water supply mop
kit may cause static electricity.
* Water only.
Correct
6 After using, pour out any
remaining water from the
water supply mop kit.
LED is OFF
Full battery
Wrong
English 5