How To Setup The Piano; Important Notes - Roland 3000S Owner's Manual

IMPORTANT NOTES
Power Supply
Do not use the same socket that is used for any
noise generating device, such as a moter or vari-
able lighting system.
This unit might not work properly if the power
cable is plugged in with the unit turned on. If this
happens, simply turn the unit off, and turn it on
again in a few seconds.
The appropriate voltage to be used is shown on
the name plate on the rear panel. Be sure that
the voltage system in your country meets the
requirement.
Power Cord
When disconnecting the power cord from the
socket, do not hold the cord but the plug. When
the unit is not to be used for a long period, dis-
connect the power cord.
Location
* Operating this unit near a neon or fluorescent
lamp may cause noise interference. If so, change
the angle or position of the unit.
* Avoid using this unit in extreme heat or humid-
ity or where it may be affected by dust.
Cleaning
* Use a soft cloth and clean only with a mild
detergent.
е Do not use solvents such as paint thinner.
HOW TO SETUP THE PIANO
1. Connect the supplied power cord to the
Receptacle (B on the rear panel.
2. Connect the plug to the wall socket.
* Be sure to take step 1 then 2. Do not do it the
other way round.