Troubleshooting - Beast Blend B6 HEALTH BLENDER User Manual

Troubleshooting

Please refer to the "B6 LED Light Behavior" section on
page 11.
• If the LED light indicator displays:
No Visible Light
That Means: Your blender unit is not powered on.
Try: Make sure that the Blender Base is plugged into a
functioning standard 120-volt AC electrical outlet. Then
power ON the unit by pressing the Power Switch at the
back of the unit.
• If the LED light indicator displays:
Solid Amber Color Light
That Means: Your blender unit is powered on, but the Blade
Assembly and/or Blending Vessel is not properly connected.
Try: Confirm that the Blade Assembly is firmly threaded
onto the Blending Vessel. Then confirm that the Blade As-
sembly and Blending Vessel are twisted onto the base until
it clicks into place and the LED indicator displays a Solid
White color light.
• If the LED light indicator displays:
Solid Green Color Light and
does not blend
That Means: The motor is overloaded.
Try: Power OFF the unit by pressing the Power Switch on
the back of the unit. Wait 30 seconds for the unit to reset.
Then:
1. If the contents of the Blending Vessel appear to be
stuck in place, perform the "Shake Method" listed in the
"Tips & Tricks" section to free up the ingredients before
continuing blending.
2. If the Blending Vessel is filled beyond the Max Fill line,
remove the Blade Assembly from the Blending Vessel.
Remove enough contents to bring the fill level down to or
below the Max Fill line. Then go to step 4 of the "How to
Use Your B6 Blender" section to continue blending.
3. If the LED light indicator continues to display a Green light,
but does not blend, the motor itself may be overheated and
will require time to cool down. Power OFF the unit, and
allow to cool for one hour before attempting to blend again.
19
Troubleshooting
• If the LED light indicator displays:
Flashing Red Color Light
That Means: The contents of the Blending Vessel are too
hot to safely blend.
Try:
1. Power OFF the unit by pressing the Power Switch on the
back of the unit. Wait for 30 seconds for the unit to reset
before powering back on.
2. Make sure that the contents of the Blending Vessel are at
or below room temperature before continuing to blend.
• If your Beast Blender motor sounds like it is laboring
and blending is not efficient that means: Your Blending
Vessel may be overfilled, or Blending Vessel contents
may be stuck.
Try:
1. If the contents of the Blending Vessel appear to be stuck
in place, perform the "Shake Method" listed in the "Tips &
Tricks" section to free up the ingredients before continu-
ing blending.
2. If the Blending Vessel is filled beyond the Max Fill line,
remove the Blade Assembly from the Blending Vessel.
Remove enough contents to bring the fill level down to or
below the Max Fill line. Then go to step 4 of the "How to
Use Your B6 Blender" section to continue blending.
20