Vessel Fill Example Chart; Tips & Tricks - Beast Blend B6 HEALTH BLENDER User Manual

Vessel Fill Example Chart

The below chart provides examples of ingredient types,
amounts, and time required to blend/grind in each vessel.
TYPE
LOAD
Carrots
BLENDING
+ Water
Wheat,
GRINDING Rice,
Corn
Carrots
BLENDING
+ Water
Max Fill Lines for Blending
415mL Vessel has a 529mL Vessel has a
maximum fill volume maximum fill volume
of 275mL when used of 400mL when used
for blending for blending
PLEASE NOTE: if your Blending Vessel is overfilled and the Blade
Assembly is not screwed on tightly at the beginning of the blending
cycle, your blend ingredients could spill into the threading and cause
your Blending Vessel to get stuck to the Blade Assembly. This is why it
is very important to follow the Max Fill Lines For Blending. However, if
this does happen, refer to our FAQs for tips at www.thebeast.com.
17
ATTACHMENT CAPACITY
638mL
Blending Vessel 200g
(500mL Max Carrots
Fill) with Blade 300g Water
Assembly
638mL
Blending Vessel
(500mL Max 350g
Fill) with Blade
Assembly
415mL
Blending Vessel 100g
(275mL Max Carrots
Fill) with Blade 150g Water
Assembly
638mL Vessel has a
maximum fill volume
of 500mL when used
for blending
Tips & Tricks
Shake Method to Loosen Stuck Ingredients
When blending tough foods, large ingredients, or with a
limited amount of liquid in the vessel, the contents of the
Blending Vessel may become stuck and require a manual
BLEND
method of freeing up the contents in order to continue
CYCLE
blending.
1. Remove the Blade Assembly with Blending Vessel
60s
from the Blender Base.
2. With the Blade Assembly and Blending Vessel in
hand, shake it up and down thoroughly.
60s
3. Reattach to the Blender Base to finish blending.
60s
Coarsely Chop Ingredients by Pulsing
Pulsing is a useful way to coarsely chop ingredients
without totally emulsifying them. This method is particularly
useful for grinding coffee beans, making chunky salsa,
chopping onions, and adding chunks of ingredients to an
already smooth mixture for texture.
To Pulse:
1. Press the Standby Switch on the front of the unit for
less than 1 second.
2. Repeat until you achieve your desired texture.
18