Allo RemoteControl SOMMER 4004 Instructions

Advertisement

Remote-to-remote programming:

1. Open both remote controls by their sides and connect the two fobs
2. When the LEDs light up and then go off, press the button 1 on the new remote
control and hold it down
3. When The LED of your old remote control comes off, press and hold the
second button until the LED switches off.
4. Your new remote control is programmed!
Visit our Website. www.alloremotecontrol.com
SOMMER 4004 – 4050
INSTRUCTIONS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SOMMER 4004 and is the answer not in the manual?

Questions and answers

Summary of Contents for Allo RemoteControl SOMMER 4004

  • Page 1 INSTRUCTIONS SOMMER 4004 – 4050 Remote-to-remote programming: 1. Open both remote controls by their sides and connect the two fobs 2. When the LEDs light up and then go off, press the button 1 on the new remote control and hold it down 3.
  • Page 2 Receiver-based programming: 1. Disconnect your receiver. It is located next to your motor. 2. Open the casing of your receiver 3. On the receiver circuit board (2), connect the remote control as indicated in the diagram above (1). The LED on the receiver lights up (4).

This manual is also suitable for:

Sommer 4050

Table of Contents