Allo RemoteControl ALLDUCKS 6204 Instructions

INSTRUCTIONS

ALLDUCKS 6204

The LED

 Simultaneously, press and hold the buttons "on" and "off" of your new remote control

 The LED flashes, comes off then on again

 Release the buttons

 Your new remote control is now in learning mode

 Press the button on your new remote control that you want to program

 The LED comes on

 Release the button

 Enter your personal code by pressing 12 times the buttons on and off

 For every push, wait until the LED comes on then off. Release the button

 Create your own code

 Press both buttons of your remote control

 The LED flashes, comes off then on again

 Release both buttons

 Press the button you wish to program

 Enter the code by pressing 12 times on the on and off buttons

 Connect your new remote control to your receiver

 Press channel 1 of your receiver

Visit our website: www.Alloremotecontrol.com

Table of Contents

Do you have a question about the ALLDUCKS 6204 and is the answer not in the manual?

Page 1 INSTRUCTIONS ALLDUCKS 6204 The LED  Simultaneously, press and hold the buttons “on” and “off” of your new remote control  The LED flashes, comes off then on again  Release the buttons  Your new remote control is now in learning mode ...
Page 2  The LED comes on  Then press continuously the button on your remote control while the LED of your receiver is on  Wait until the LED of your receiver comes off then turns on again  Release the button on your remote control ...