Advertisement
SEA Head 433 2 – Head 433 4 – Head 868 MHz
How to program your new remote control:
There are different methods you can use to program your new remote control
Remote-to-remote programming:
1.
Approach your motor so you are standing a few feet away from it.
2.
Open the casing of your already-programmed remote control.
3.
Press the button T5 for 1 second (fig 1). The LED light D1 on your already-programmed
remote control illuminates and then turns off. Let the button T5 go.
4.
During the following 5 seconds, press the button you wish to program on your new remote
control. Let it go.
5.
Repeat this procedure for each button you wish to program.
6.
Wait 10 seconds.
7.
Your new remote control is programmed.
You r Prog ramming Inst ructions
for you r new remote cont rol
www.AlloRemoteControl.com –
Contact@AlloRemoteControl.com
Advertisement
Table of Contents
Related Manuals for Allo RemoteControl SEA Head 433 2
Summary of Contents for Allo RemoteControl SEA Head 433 2
- Page 1 You r Prog ramming Inst ructions for you r new remote cont rol SEA Head 433 2 – Head 433 4 – Head 868 MHz How to program your new remote control: There are different methods you can use to program your new remote control Remote-to-remote programming: Approach your motor so you are standing a few feet away from it.
- Page 2 Prog ramming Inst ruction Receiver-based programming: ATTENTION: if you keep the p rog ramming button of you r receive r p ressed down too long, you will e rase the p rog ramming code of all of you r remote cont rols that ha ve al ready b een p rog rammed Open the casing of your receiver.
Need help?
Do you have a question about the SEA Head 433 2 and is the answer not in the manual?
Questions and answers