Table of Contents
Advertisement
Bits Per Second
Use this to select the serial port transmission speed. The speed used in the host computer
and the client computer must be the same. Long or noisy lines may require lower
transmission speed. The options include [9600], [19200], [38400], [57600] and [115200].
Data Bits
Use this to set the data transmission size. The options include [7] and [8] (Bits).
Parity
Use this to select the parity bit. The options include [None], [Even], [Odd], [Mark] and
[Space].
Stop Bits
The item indicates the end of a serial data packet. The standard setting is [1] Stop Bit. Select
[2] Stop Bits for slower devices.
Flow Control
Use this to set the flow control to prevent data loss from buffer overflow. When sending
data, if the receiving buffers are full, a "stop" signal can be sent to stop the data flow. Once
the buffers are empty, a "start" signal can be sent to restart the flow. Hardware flow uses
two wires to send start/stop signals. The options include [None] and [Hardware RTS/CTS].
VT-UTF8 Combo Key Support
Use this to enable or disable the VT-UTF8 Combo Key Support for ANSI/VT100
terminals.
Recorder Mode
Use this to enable or disable Recorder Mode to capture terminal data and send it as text
messages.
Resolution 100x31
Use this to enable or disable extended terminal resolution support.
Putty Keypad
Use this to select Function Key and Keypad on Putty.
Serial Port for Out-of-Band Management/Windows Emergency
Management Services (EMS)
Console Redirection EMS
Use this to enable or disable Console Redirection EMS. If this item is set to Enabled
allowing to select a COM Port to be used for Console Redirection.
Console Redirection Settings
Use this to configure Console Redirection Settings, and specify how the computer and the
host computer to which are connected exchange information.
58
Advertisement
Table of Contents
