Fcc Statement Of Compliance; What Is Included - Chauvet DJ GigBAR MOVE + ILS Quick Reference Manual

FCC Statement of Compliance

This device complies with Part 15 Part B of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
♦ Reorient or relocate the receiving antenna.
♦ Increase the separation between the equipment and receiver.
♦ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
♦ Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.

What is Included

• GigBAR MOVE + ILS
• Power cord
• RF remote
ILS Connection
ILS (Integrated Lighting System) provides 4 modes that synchronize with the GigBAR MOVE + ILS: Modes 1 and 3
synchronize with side 1 of the GigBAR MOVE + ILS, whereas modes 2 and 4 synchronize with side 2 of the
GigBAR MOVE + ILS. When linked, effects will sync with the most similar effect on the selected side of the
GigBAR MOVE + ILS: Kinta effects will sync with one of the kintas, moving heads will sync with one of the moving heads,
and wash effects will sync with one of the pars. Laser effects will sync with the laser, and strobe effects will sync with the
strobe effects regardless of ILS mode.
GigBAR MOVE + ILS QRG Rev. 2
QUICK REFERENCE GUIDE
• Carrying bag
• Tripod
• Tripod carrying bag
• Footswitch
• Quick Reference Guide
EN
4