Advertisement
EN
without grass as a boundary.
NOTE (only for Landroid Vision): Make sure the magnetic strip is installed 32 cm away from the protected area and
border. The starting and ending points of the magnetic strip should be in an arc shape.
H. Narrow passage (See Fig. 20)
Make sure the narrow passage for Landroid Vision to pass is wider than 1 m.
NOW ROLL YOUR SLEEVES UP. WHEN IT'S DONE IT'S DONE!
Now that you have planned the installation in every detail, you are ready to take action. Before starting, you may want to use your
old mower for the last time to clean up your lawn and make the installation easier.
3.2 INSTALL THE CHARGING BASE
Position the charging base
Option A: Position the charging base at the corner of your lawn (See Fig. 21)
To enter the charging base, Landroid Vision needs at least 2 m straight path in front and 5-15 cm away from the boundary of the
lawn.
Option B: Position the charging base on one side of your lawn (See Fig. 22)
To enter the charging base, Landroid Vision needs at least 2 m straight path in front and 5-15 cm away from the boundary of the
lawn. It needs at least 1.5 m behind the charging base to make sure the grass can be cut.
Option C: Position the charging base in the corner outside the lawn (See Fig. 23)
Locate charging base on the extension line and 5-15 cm away from the edge. To enter the charging base, the charging station
should be placed near the edge of the lawn.
Charging base checklist:
A. within reach of AC mains
B. in shade (if possible)
C. no obstacles, and no area of sparse grass within the 2 m straight path to the charging base
D. flat or level location
E. no irrigation sprinklers nearby
Fix the charging base in the selected location
A. Compose the charging base plate, flatten and tighten the conjunction. (See Fig. 24)
B. Insert charging tower into charging base plate. Then fix the charging base to the ground by means of the supplied screws,
using the supplied hex key. (See Fig. 24)
C. If you position the base on hard surface, fix it with plug and screw fixings.
NOTE: It is recommended to assemble the charging base on a flat and hard surface.
3.3 INSTALL THE RFID (See Fig. 25)
A. The distance from the centre of the RFID to the front and rear lawn boundaries needs to be greater than 1.5 m.
B. Make sure the center of the RFID is 50-60 cm away from the lawn edge, fix the RFID with 2 screws.
C. Put another RFID symmetrically in the opposite zone and fix it.
3.4 CONNECT CHARGING BASE TO AC
There are only a few more steps to go:
A. Connect the charging base to the AC mains socket. (See Fig. 26)
B. If everything is fine, the LED will light green.
C. Open the cover of the battery enclosure and insert the PowerShare battery into the slot until it clicks. Then close the cover.
(See Fig. 27)
D. Place Landroid Vision on charge by making sure a deep contact is established with the base. (See Fig. 28) The LED will blink
green; once the battery is fully charged, the LED will turn solid green.
E. Let the battery get charged for a while. Whilst it is charging you may want to take a well-deserved break: get familiar with the
following instructions, and connect Landroid Vision to your Wi-Fi network.
8
Advertisement
