Kenwood KR-897 Instruction Manual page 13

KR-B97iKR-797 (En)
0 eration rocedure
r_ Switch ON the power ofthe main uni£
_ Select the component to be remote controlled
with one of the controlled component selection
keys.
D Refertotheremotecontrolkeycorrespondence
table below and press the key for the desired
operation.
• Pressingthe POWER key of the remote control unit while the STANDBY
indicator is fit turns the power ON. Press the desired key after the
power has been turned ON.
• When two operation keys of the re_ote control unit are pressed
successively, press each key sec_ref_ reserving an interval of more
than 1 second for each press
Remote control key correspondence table
Controlled component
selection key TUNER
SlOperation ke_
pe.< lpl_l
L P.CALL -_
P.CALL keys
Recalls preset stations.
'ForKENWOOD corn
CD
CD
(Skip key)
tonent control mode)
TAPE1
TAPE1 el (_
O I (When used with a MD)
(Skip key)
(_ AUTO key m [] []
Press to select the auto
AUTO tuning mode. (Stop key) (Stop key) (Stop key)
BAND key
Press to switch the broad-
cast band.
(Tuning keys)
Press to tune broadcast
stations.
DISK SKIP
CZ)
A/B .100
DISC SKIP key
Press to select the discto
be played,
I_III
(Play/pause key!
.<l<l,ll_l_
(Search key)
A/B key
Press TAPE A orb
I_/11
(Forward play key)
(Search key)
-el
(Reverse play key)
1-111
CD
BAND
CDCD
CD
+100
1-111
(Play key)
4Pel , 10H_
(Search key)
Approximate operating range l_- _,
Re•too°ire
Model: RC-R0505 --'
Infrared ray system
• .1: NO remote control key is marked MD. but the
TAPE1 key can be used to control a MD player by
switching the display of the main unit from TAPE 1
to Me. -_
_s 1. The-supplied batteries are intended for use in operation checks. Therefore. their lives may be shorter than ordinary batteries.
2. When the remote-controllable distance gets shorter than before, replace both batteries with new ones,
3. Malfunction may occur if direct sunlight or the light of a high-frequency lighting fluorescent lamp enters the remote control light
sensor In such a case. change the system installation position to prevent the malfunction.