Enabling And Viewing Snmp Logs; To Enable Logging Of Snmp Messages; Multi Router Traffic Grapher Example - Watchguard SSL 1000 User Manual

Field
sc-status
cs-uri
sc-uri
To view or download the log, go to the Logging > Configuration tab and click Download W3C Log.

Enabling and Viewing SNMP Logs

When Simple Network Management Protocol (SNMP) is enabled, the Firebox SSL VPN Gateway reports
the MIB-II system group (1.3.6.1.2.1). The Firebox SSL VPN Gateway does not support Firebox SSL VPN
Gateway-specific SNMP data.
You can view SNMP messages in the Administration Tool and you can configure an SNMP monitoring
tool such as the Multi Router Traffic Grapher to provide a visual representation of the SNMP data
reported by the Firebox SSL VPN Gateway in response to queries. For a sample of Traffic Grapher output,
see "Multi Router Traffic Grapher Example" on page 139.

To enable logging of SNMP messages

1 Click the VPN Gateway Cluster tab and then click the Logging/Settings tab.
2 Under SNMP Settings, select Enable SNMP.
3 In SNMP Location, type the SNMP location. This field is informational only.
4 In SNMP Contact, type the contact. This field is informational only.
5 In Community, type the community. This field is informational only.
6 In Port, type the port.
7 Click Submit.

Multi Router Traffic Grapher Example

The Multi Router Traffic Grapher is a tool used to monitor SNMP data, such as traffic load. Multi Router
Traffic Grapher generates HTML pages containing PNG images that provide a visual representation of
the traffic. Multi Router Traffic Grapher works under UNIX, Windows 2000 Server, and Windows Server
2003.
The information in this section provides a general overview of working with Multi Router Traffic
Grapher. For information about obtaining and using this tool, visit the Multi Router Traffic Grapher Web
site at
http://people.ee.ethz.ch/~oetiker/webtools/mrtg/.
Administration Guide
Description
The Firebox SSL VPN Gateway-to-client request status code. For a description of status
codes, refer to http://www.w3.org/Protocols/rfc2616/rfc2616-sec10.html.
The client-to-Firebox SSL VPN Gateway request URI.
The Firebox SSL VPN Gateway-to-client request URI.
Note
Enabling and Viewing SNMP Logs
139