Removal And Disposal - Seeley Braemar Invertair SACV10D1S Installation Manual

REMOVAL AND DISPOSAL

This product contains refrigerant under pressure, rotating parts and electrical connections which may be a danger and cause injury!
All work must only be carried out by qualified, licensed, competent persons using suitable protective clothing and safety precautions.
1. Isolate all sources of electrical supply to the unit including any control system supplies switched by the unit. Ensure that all points
of electrical and gas isolation is secured in the OFF position. The supply cables and gas pipe-work may then be disconnected and
removed. For points of connection refer to unit installation instructions.
2. Remove all refrigerant from each system of the unit into a suitable container using a refrigerant reclaim or recovery unit. This
refrigerant may then be reused, if appropriate or returned to the manufacturer for disposal. Under no circumstances should
refrigerant be vented to atmosphere! Where appropriate, drain the refrigerant oil from each system into a suitable container and
dispose of according to local laws and regulations governing disposal of oily wastes.
3. Packaged unit can generally be removed in one piece after disconnection as above. Any fixing down bolts should be removed and
then unit lifted from position using the points provided and equipment of adequate lifting capacity. Reference MUST be made to
the unit installation instructions for unit weight and correct methods of lifting. Note that any residual or spilt refrigerant oil should
be mopped up and disposed of as described above.
4. After removal from position the unit parts may be disposed of according to local laws and regulations
Note!
For complete warranty terms and conditions, refer to separate Warranty Booklet and/or www.braemar.net.au
Warranty conditions are subject to property access and industry Safety Standards.
Seeley International strives for continuous product improvements, therefore specifications are subject to change without notice. Unit
colour may vary slightly from that depicted in this booklet.
Installation and commissioning of this system to the manufacturer's specification, compliance with industry standards, and local,
state and national regulatory codes are the responsibility of the installer.
Information in this booklet was true and correct at the time of publishing. E & OE.
ILL2007-A
SEELEY INTERNATIONAL - INSTALLATION MANUAL |
27