Watchguard V10 Hardware Manual page 15

Do not connect any Firebox Vclass appliance to a source of power that
supplies the wrong voltage. Doing so will damage the appliance and void
the warranty.
In the event of a power failure, this security appliance, if left connected to
the power source, will automatically restart itself after electrical power
has been restored. You do not have to press either the Power button on the
front or the power supply switch on the back of the appliance.
The Vclass 100 model
The front panel of the Firebox Vclass 100 security appliance contains the
features shown in the following illustration.
Hardware Guide
AC power
Enables you to connect the appliance (using the supplied power
cord) to a 100 to 240VAC (50/60Hz) power source.
Power switch
Allows you to turn the appliance on or off.
Amperage switch
Allows you to change the power source between 115 and 230
volts, depending upon your supply. The power supply can auto-
detect 110/220 voltage.
UPS interface
Permits connection of the appliance to an Uninterruptable Power
Supply (UPS). This type of connection enables UPS devices to
notify the appliance if the power goes out, prompting the
appliance to shut itself down properly.
UPS devices from American Power Company (APC) are currently
supported by the Firebox Vclass power management firmware.
Check the WatchGuard Web site (www.watchguard.com) for
updated information on complete UPS support.
N
OTE
N
OTE
Front and Back Views
7