Watchguard V10 Hardware Manual page 14

PART V: Administering a Security Policy
The back panel of a Firebox V60 or V80 contains the features shown in the
following illustration.
6
Data interfaces
Four accelerated, Ethernet interfaces (RJ-45 connectors) labeled 0
(Private), 1 (Public), 2 (DMZ1), and 3 (DMZ2) act as the primary
conduits through which passes all of the network data traffic.
Incorporated into each interface are two indicator lights labeled 10
and 100. These LEDs indicate the speed of traffic being
transmitted.
HA status LED
Indicates the current status of this appliance, if it is one of two
connected as a high-availability system. If this is the primary
appliance, and the light is on and steady, the system is functional,
and this appliance is on-line. If this is the primary appliance and
the LED is blinking, a failover has occurred and the secondary
appliance is online.
Console interface
A single RJ-45 interface, labeled Console, permits a direct
workstation-to-appliance connection. You can use the
WatchGuard Command Line Interface (CLI) to configure and
administer this appliance. For more information about this
administrative option, see the CLI Guide.
Reset port
This opening allows you to insert a straight pin or paperclip and
press an internal reset switch that restarts the appliance.
WatchGuard Firebox Vclass