Panasonic Digital Palmcorder PV-DV52 Operating Instructions Manual page 39

6,
7PAUSE
To listen to the desired audio sound, set
the AUDIO setting of the VCR mode MENU
(Menu OSD: p. 61) as follows:
AUDIO:The following selections are
available for 12 bit AUDIO dubbed
recordings only (sound recorded in SP
mode only).
Set this position to listen to the
ST 1 original sound.
Set this position to listen to the
ST2 audio dubbed sound.
Set this position to listen to both
MIX the original sound and the audio
dubbed sound.
• 16 bit dubbed sound completely erases
the original 16 bit recorded sound.
• If you dubbed using 12 bit AUDIO
recording and then selected AUDIO-MIX
in the menu for playback, the sound will
be stereo regardless of the AUDIO-OUT
setting.
• If you recorded in LP mode, you cannot
use the A.DUB feature.
6
Press II (PAUSE) to start Audio
Dubbing.
• Connect the Palmcorder to the TV in
order to monitor the sound.
(p. 33)
I i _COa_,,T i KE
OATA
Only NTSC (National Television Standards
Committee) recorded tapes can be audio
dubbed. The following screen appears if
the tape was not recorded in NTSC format.
Press II (PAUSE) to stop Audio
Dubbing.
• If the microphone used for dubbing gets
too near the speaker of your TV,
a howling noise (feedback) may occur.
• If the tape position is in or was started in
a blank section, you cannot use the
A.DUB feature.
39