Initial Setup - Magnavox 32MF338B User Manual

[] Initial Setup
This sectionwill guide yon through theTV'sinitialsetting which includes
selectinga languageforyouron-screen menuandantoprogram, which
automatically scansand memorizesviewable channels,
Before youbegin:
Makesureifthe TVisconnected t o antenna orcables,
_ After making all the necessary connections, press
[POWER O] to turn on the TV.
. This operation may take a few moments.
_ Use [Cursor A/V] to select the on-screen language
from the choices on the right side of the TV screen.
(English / Espaflol / Fran_ais)
OF
Note:
• If you connect the cable system directly, contact the CATV
installer.
• If you press [POWER 0 ] or [MENU] during autoprogram,
this setting will be canceled.
• The initial autoprogram function can be executed for
either "Air"or "Cable" only once. When you change the
connection (Air/Cable), set autoprogram again. (Refer to
page 15.)
• You can cancel or exit the initial autoprogram menu by
pressing [MENU].
• Ifthereisnosignalinputfrom theantenna terminaland
no operation for several seconds after you turn on the TV,
"Helpful Hints" appears. Follow the instructions listed on
the TV screen.
. "Initial Setup" menu on step 3 will be displayed in the
selected language after you press [OK].
_ Use [Cursor A/V] to select "Air" for TV channels or
"Cable" for CATV channels, then press [OK].
or
. Scanning and memorizing of channels start
automatically.
. When the scanning and memorizing ofchannelsare
completed, the lowest memorized channel will be
displayed.
EN