Faq - Magnavox 32MF338B User Manual

[] FAQ
. Check the antenna or cable connection to the main TV.
. Check the batteries of the remote control.
. Check if there is an obstacle between the infrared sensor window and
the remote control.
. Test the signal output. If OK, then possible infrared sensor trouble.
(Refer to"lR Signal Check" on page 36.)
My remote control does not work. What . Aim the remote control directly at the infrared sensor window on the
should I do? front of theTV.
. Reduce the distance to theTV.
. Re-insert the batteries with their polarities (+/- signs) as indicated.
. When there is an infrared-equipped device such as PC near this TV, it
may interrupt the remote control signal of this TV.
. Move the infrared-equipped device away from this TV, change the angle
of the infrared sensor or turn offthe infrared communication function.
How Come the Initial Setup appeais eveiy i connect theRF Cable tOthe TV directly and run the initial setup:
time I turn on thisTV? . Make Sure to complete the Channel Scan before turning off the TV.
. Make sure autoprogram has been completed.
(Refer to "Autoprogram" on page 15.)
. Autoprogram must be completed when you set up the TV for the first
time or move it to a location where previously unavailable channels are
broadcast.
. The selected channel may not be broadcasting.
Why I cannot watch some of TV programs? . When autoprogram is interrupted and not completed, some channels
will not be received. Make sure to complete.
(Refer to "Autoprogram" on page 15.)
. The selected channel cannot be viewed by the Parental control setting.
(Refer to "Parental Control" on page 29.)
. TheTV requires some kind of antenna input. An indoor antenna (rabbit
ears), an external antenna, or an RF coaxial cable from your wall or cable
receiver/satellite box needs to be plugged into the TV.
How Come there is no image from the _ CheCk if the right input mode is SeieCted by pressing [SouRcE] or using
[CH° + / _ ]. (Refer to i!Switching Each Input Model' on Page ! 8.)
connected externaldevices? . Chec_____kthe tenna o rcabl____e connec on to t TV.
. Many digital channels have alternate channel numbers.TheTV changes
Whenever I entered channel number, the numbers automatically to the ones signifying the broadcasting
it changes automatically, stations. These are the numbers used for analog broadcasts.
' captions that are delayed a few seconds behind the actual dialogue are
Why are captions not displayed entirely? common for live broadcasts, Most captioning production companies Can
Or, captions are delayed behind the display a dialogue to maximum of 220 words per minute. Ira dialogue
dialogue, exceeds that rate, selective editing is used tO insure that the captions
', remain up'to date with t hecurrentl-V screen dialogue.
How can I set the clock? . There is no clock function on this TV.
ii!_iiii_
il_iiiiiii
EN