DeWalt DCLE34033 Manual page 23

Accessories
The laser is equipped with both 1/4 - 20 and 5/8 - 11
female threads on the bottom of the unit (Figure
). This thread is to accommodate current or future
D WALTaccessories. Only use D
E
specified for use with this product. Follow the directions
included with the accessory.
WARNING:
Since accessories, other than those offered
by D WALT, have not been tested with this
E
product, use of such accessories with this
tool could be hazardous. To reduce the
risk of injury, only DEWALT recommended
accessories should be used with this product.
If you need any assistance in locating any accessory,
please contact your nearest D
go to www.DEWALT.com.
Target Card
Some laser kits include a Laser Target Card (Figure
to aid in locating and marking the laser beam. The
target card enhances the visibility of the laser beam as
the beam crosses over the card. The card is marked
with standard and metric scales. The laser beam
passes through the green plastic and reflects off of the
reflective tape on the reverse side. The magnet at the
top of the card is designed to hold the target card to
ceiling track or steel studs to determine plumb and level
positions. For best performance when using the Target
Card, the D WALT logo should be facing you.
e
Ceiling Mount
The laser ceiling mount (Figure
mounting options for the laser. The ceiling mount has a
clamp (Figure ) at one end which can be fixed to a
L 2
wall angle for acoustic ceiling installation (Figure
At each end of the ceiling mount is a screw hole (Figure
and ), allowing the ceiling mount to be
L 4 L 5
attached to any surface with a nail or screw.
K
WALT accessories
E
WALT service center or
E
M
) offers more
L 1
).
L 3
Once the ceiling mount is secured, its steel plate
provides a surface to which the magnetic pivot bracket
(Figure ) can be attached. The position of the
L 6
laser can then be fine-tuned by sliding the magnetic
pivot bracket up or down on the wall mount.
Service and Repairs
NOTE: Disassembling the laser level(s) will void all
warranties on the product.
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment should be performed by
authorized service centers. Service or maintenance
performed by unqualified personnel may result in a risk
of injury. To locate your nearest D
call 1-800-4-DEWALT (1-800-433-9258) or go to
www.toolservicenet.com.
Warranty
Go to www.DEWALT.com for the latest warranty
information.
)
WALT service center
E
23
E