DeWalt DCLE34033 Manual page 18

overloading, overheating or deep discharge. The tool
E
will automatically turn off and the battery pack will need
to be recharged.
Important Charging Notes
1. Longest life and best performance can be
obtained if the battery pack is charged when
the air temperature is between 65 °F – 75 °F
(18 ° C– 24 °C). DO NOT charge when the battery
pack is below +40 °F (+4.5 °C), or above +104 °F
(+40 °C). This is important and will prevent serious
damage to the battery pack.
2. The charger and battery pack may become warm
to the touch while charging. This is a normal
condition, and does not indicate a problem. To
facilitate the cooling of the battery pack after use,
avoid placing the charger or battery pack in a
warm environment such as in a metal shed or an
uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check operation of receptacle by plugging in a
lamp or other appliance;
b. Check to see if receptacle is connected to a
light switch which turns power off when you turn
out the lights;
c. If charging problems persist, take the tool,
battery pack and charger to your local
service center.
4. You may charge a partially used pack whenever
you desire with no adverse effect on the
battery pack.
Charger Cleaning Instructions
WARNING: Shock hazard. Disconnect the
charger from the AC outlet before cleaning.
Dirt and grease may be removed from the
exterior of the charger using a cloth or soft
non‑metallic brush. Do not use water or any
cleaning solutions.
18
Operating Tips
• To extend battery life per charge, turn the laser off
when it is not in use.
• To ensure the accuracy of your work, check the
laser calibration often. Refer to Checking Laser
Accuracy.
• Before attempting to use the laser, make sure it is
positioned securely, on a smooth, flat stable surface
that is level in both directions.
• To increase beam visibility, use a Laser Target Card
(Figure ) to help find the beam.
M
• Always mark the center of the beam created by the
laser.
• Extreme temperature changes can cause movement
or shifting of building structures, metal tripods,
equipment, etc., which can effect accuracy. Check
your accuracy often while working.
• If the laser has been dropped, check to make sure
your laser is still calibrated. Refer to Checking Laser
Accuracy.
Turning the Laser On
Place the laser on a flat level surface. Slide the Power/
Transport Lock switch
C 2
ON the laser.
Each laser line is powered on by pressing its button on
the keypad (Figure
C 3
turns the laser line off. The laser lines can be powered
one at a time or all at the same time.
Button
Horizontal laser line (Figure
Side vertical laser line (Figure
Front vertical laser line (Figure
to the right to unlock/turn
). Pressing the button again
Displays
)
C 4
C 5
C 6
)
)