Advertisement
Quick Links
Introduction
Purpose
This manual provides reference information for FlexPay
Table of Contents
Topic
Introduction
Setup Information for Side-by-Side Simulators
Verification Codes
Reference Documents
The following table lists the reference documents for specific information:
Required Information
Start-up
Desktop Simulators Installation
Side-by-Side Simulators Installation
Troubleshooting
M7 Software Tool
Pump Simulation Programming
MDE-5295D FlexPay™ IV Simulator Reference Sheet · July 2019
FlexPay
™
Page
1
3
5
Reference Document
MDE-5221 FlexPay IV CRIND
®
• MDE-5220 FlexPay IV CRIND Retrofit Kit Installation Instructions for
Encore
S E-CIM
®
™
• MDE-5369 FlexPay IV (with Omnia) Programming and Service Manual
MDE-5222 FlexPay IV CRIND Retrofit Kit Installation Instructions for
Encore 300/500
MDE-5223 FlexPay IV CRIND Service/Troubleshooting Guide
MDE-5227 M7 Maintenance Tool User Guide
MDE-3860 Programming Quick Reference Guide
IV Simulator Reference Sheet
IV/M7 simulators.
™
Start-up Manual
MDE-5295D
July 2019
Page 1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for GILBARCO VEEDER-ROOT FlexPay IV
Summary of Contents for GILBARCO VEEDER-ROOT FlexPay IV
- Page 1 Reference Document Start-up MDE-5221 FlexPay IV CRIND Start-up Manual ® Desktop Simulators Installation • MDE-5220 FlexPay IV CRIND Retrofit Kit Installation Instructions for Encore S E-CIM ® ™ • MDE-5369 FlexPay IV (with Omnia) Programming and Service Manual Side-by-Side Simulators Installation...
-
Page 2: Abbreviations And Acronyms
Technical Assistance Center Universal Payment Module Overview The FlexPay IV/M7 simulators use most of the same components and wiring harnesses as used in dispensers. One major difference between simulators and dispensers is the internal keys that the secure components [Universal Payment Module (UPM) keypad and UX300 card reader] use to communicate within the system. - Page 3 Setup Information for Side-by-Side Simulators Setup Information for Side-by-Side Simulators The simulator has five cords exiting the back of the enclosure as shown in Figure Figure 1: External Power and Wiring Power 2W A (Pump) 2W B (CRIND) Side A Intercom Call Button Side B Intercom Call Button Connect to power and to the existing two-wire framework depending on the environment.
-
Page 4: Internal Connections
Pair White Wire Pair Pump Board For FlexPay IV, the top center board can be one of the following: • Cloud Connecting Processor (CCP) • CCP with Secure Systems on Module (SSoM) [for Remote Management and Internet Protocol (IP) routing] •... - Page 5 Verification Codes To configure the CRIND, refer to the “Reference Documents” section on page The simulator is shipped with the pump in standalone mode. Ensure that you enable the pump two-wire through the manager keypad (refer to MDE-3860 Programming Quick Reference Guide) and set the pump ID for your system.
- Page 6 CRIND , Encore , and Gilbarco are registered trademarks of Gilbarco Inc. E-CIM , FlexPay , and Passport are trademarks of ® ® ® ™ ™ ™ Gilbarco Inc. VeriFone is a registered trademark of VeriFone Inc. ® © 2019 Gilbarco Inc. 7300 West Friendly Avenue ·...
Need help?
Do you have a question about the FlexPay IV and is the answer not in the manual?
Questions and answers
How do I print liquid status on Gilbarco Veedaroot?