Parkside POF 1200 E4 Translation Of The Original Instructions page 30

GB MT
6. Hold the device tightly with both hands
while working. While doing so, ensure
none of your fingers protrude into the
area beneath the drive unit and mill
with a consistent feed motion (Fig. F) .
7. Turn off the device.
WARNING! Risk of injury! After the
device has been switched off, the cutter
continues moving for some time. Do not
touch the moving cutter and do not put the
device down before the cutter has come to
a complete standstill.
Edge and profile cutting
The cutter must be equipped with
a stop ring (a) as guide when
edge or profile cutting without
parallel guide.
a
Procedure
1. Move the turned on device to the work-
piece until it sits on the stop ring on the
workpiece edge to be processed.
2. Move the device with both hands
along the workpiece edge. Avoid ex-
cessive pressure.
Milling with parallel guide
You can mill grooves and profiles with the
parallel stop by moving the parallel guide
along the workpiece edge at a pre-set dis-
tance.
NOTICE! Solid materials can only be
milled in small steps (max. 1-2 mm cutting
depth). Deeper grooves must be milled in
several steps.
Procedure
1. Fitting and removing the parallel
guide, p. 27
2. Set the milling depth to 1-2 mm (Set-
ting the milling depth, p. 28).
30
3. Make sure that the parallel guide (15)
lies against the workpiece edge cor-
rectly.
4. Switch on the device.
5. Move the device along the workpiece
edge with lateral pressure on the par-
allel guide (15). The parallel guide
(15) acts as a lateral guide.
NOTICE! Continuously check that the
groove has a right angle.
6. Repeat work steps 4-5 until you
achieve the desired result.
Milling with centring tip
By means of the centring tip, you can do
circular milling work.
Tools and aids required
• Open-end wrench (22)
Procedure (Fig. G)
1. Turn the parallel guide (15) around so
that the stop edge points upwards (Fit-
ting and removing the parallel guide,
p. 27).
2. Screw the centring tip (31) onto the
parallel guide. While doing to, counter
lock the centring tip in the long hole of
the combination wrench (22).
3. Push the centring tip (31) into the
marked centre of the circle to be
milled.
4. Guide the device like a compass once
in a circle around the centring tip.
Milling small radii
Procedure
1. Loosen the screws on the jaws (17) of
the parallel guide (15).
2. Pull the jaws (17) apart as far as they
will go.
3. Refasten the jaws (17) with the screws.
The centring tip can now be moved
closer to the machine.