Disposal/Environmental Protection; Troubleshooting - Parkside POF 1200 E4 Translation Of The Original Instructions

GB MT
Disposal/
environmental
protection
The device, accessories and packaging
should be properly recycled.
Electrical devices must not be dis-
posed of with domestic waste.
The symbol of the crossed-out wheeled bin
means that this product must not be dis-
posed of as unsorted municipal waste at
the end of its useful life.

Troubleshooting

The following table will assist you in fixing faults:
Problem
Device does not start
Engine is slowing down and
stops
Device works with interrup-
tions
Milling progresses unevenly Parallel guide (15) not inser-
32
Directive 2012/19/EU on waste
electrical and electronic equip-
ment:
Consumers are legally obliged to recycle
electrical and electronic equipment in
an environmentally sound manner at the
end of its life. In this way, environmentally
friendly and resource-saving recycling is
ensured.
Depending on the implementation in na-
tional law, you may have the following op-
tions:
• Return to a shop,
• Hand over to an official collection
• Return to the manufacturer/distributor.
This does not affect accessories enclosed
with the old devices or tools without any
electrical components.
Possible cause
No mains power supply
On/Off switch (10) is
broken
Defective motor
Device is overloaded through
workpiece
Internal loose contact
On/Off switch (10) is
broken
ted
point,
Error correction
Check the socket, mains con-
nection cable, plug and fuse
and have them repaired by a
qualified electrician if neces-
sary.
contact the service centre.
contact the service centre.
Reduce pressure on attach-
ment tool
Workpiece unsuitable
contact the service centre.
Fitting and removing the par-
allel guide, p. 27