Sony Cyber-shot DSC-RX100M3 Service Manual page 30

Assembly-1: Notes on installing the FP-2234 Flexible Board
Arrange the FP-2234 Flexible Board as shown in the figure.
Note: If do not arrange it correctly, the flash may not open and
shut normally.
FP-2234 Flexible Board
Lens Cushion Upper
Lens Cushion Lower
DSC-RX100M3/RX100M3G_L2
Assembly-2: Notes on installing the Lens Ring
1. Set the Lens Ring so that its character part faces in the same direction
as the XX mark on the Manual Ring Block.
2. Attach the Lens Ring while aligning its concave with the convex of the
Manual Ring as shown in the figure.
Lens Ring
Convex
XX mark
Manual Ring Block
3. Turn the Lens Ring approx. 20 degrees clockwise to attach it.
Lens Ring
3. ASSEMBLY
Assembly-3: Notes on assembling the VF Sub Assy (Service)
VF Sub Assy (Service)
VF Sub Assy (Service)
EV-1010 Board
3-1E
Assembly-4: Notes on assembling the ST-1023 Flexible Board
Mountain fold
Valley fold
Assembly-5: Notes on assembling the Base Holder Launch
EV-1010 Board
Bosses
Mountain fold
Valley fold
ST-1023 Flexible Board
Base Holder Launch
SYS SET