Pioneer DV-585A-A Service Manual page 62

NOTE
1. In case of the Clamper Ass'y installation, install
correctly as Fig. 2-5-B.
ik
Plate Clamper —-
Check Lock
Clamper
2-6: HOLDER TRAVERSE/INSULATOR (F)/INSULATOR
(R) (Refer to Fig. 2-6-A)
1. Remove the Holder Traverse.
2. Remove the 2 Insulator (F).
3. Remove the Insulator (R).
insulator (R)
NOTE
1. In case of the Insulator (F) installation, install correctly
as Fig. 2-6-B.
Insulator (F)
Traverse Holder
2-7: SWITCH PCB ASS'Y/GEAR MIDDLE/GEAR FEED/RACK
FEED ASS'Y/FEED MOTOR (Refer to Fig. 2-7-A)
Unlock the support ®.
Remove the Gear Middle.
Remove the screw @).
Remove the Rack Feed Ass'y.
Remove the screw @).
Remove the Switch PCB Ass'y.
Remove the screw @.
Remove the Gear Feed.
. Remove the 2 screws ©).
10. Remove the Feed Motor.
11. Remove the Gear Motor.
CONOARWN =
62
Feed Motor
Gear Feed
Gear Middle
Switch PCB Ass'y
¢ Screw Torque: 1.3 + 0.3kgfecm (Screw @)
* Screw Torque: 3.0 + 0.3kgfecm (Screw @)
* Screw Torque: 1.0 + 0.3kgfecm (Screw @, ©)
NOTE
1. When installing the Rack Feed Ass'y, push both ends to
align the teeth as shown Fig. 2-7-B. Then install it.
2. In case of the Gear Motor installation, check if the value
of the Fig. 2-7-C is correct.
3. When installing the wire of the Switch PCB Ass'y, install
it correctly as Fig. 2-7-D.
Manual soldering conditions
¢ Soldering temperature: 350 + 5°C
* Soldering time: Within 4 seconds
¢ Soldering combination: Sn-3.0Ag-0.5Cu
4. After the assembly of the Traverse Ass'y, hook the wire
on the Traverse Ass'y as shown Fig. 2-7-E.
Rack Feed Ass'y
Gear Motor
8.0+ 0.2mm
Feed Motor
Safety surface for pressing
of the insert.