Jenn-Air Prostyle JGD8348CDP Installation Instructions Manual

Triple Bay C ti IG
RN
ets Bay Conventional Ses | WZ ENIN-AIR
Model JGD8348CDP 403 WEST FOURTH STREET, NORTH @ NEWTON, 1A 50208
Dimensions shown in both inches and centimenters
NOTICE TO INSTALLER: Leave these instructions with the appliance.
NOTICE TO CONSUMER: Retain these instructions for future reference.
INSTRUCTIONS
134%"
———
34.11 cm
SEE PAGE 2
SELECT APPROPRIATE
DUCT CUTOUT FOR CUTOUT
(SEE DUCTING DIMENSIONS
INSTALLATION INSTRUCTIONS.)
APPL | ANCE
15° PRESSURE REGULATOR
46 13/16"
(118.90 cm]
3 13/16"
Pp [9.68 -]
A { | _p7poumams
' [40.16 cm] 1 1 ta }
MIN.
I APPLIANCE
41 cm
Blower may be
CLEARANCE BOTTOM
LH
PRESSURE
3/4*—a|l. BOTTOM OF
rotated for horizontal EACH END
WS REQUIRED OF BAFFLE REGULATOR BURNER BOX
or vertical direction by | "BLOWER P—wike cover
loosening nuts LORAIN JAR *
around blower inlet. k- END OF
d o l e teed BURNER
Accessible inside 14e 28 11/16" BOX
ventilation chamber. v ' ™ [35.56 cm] | (72.87 cm]
INSTRUCTIONS TO INSTALLER:
A ¢« Dimension "A" - provide 2" min. (5.08 cm) cabinet clearance to motor for cooling purpose.
a ¢ NOTE: Where possible, 6" (15.54 cm) is recommended for motor/blower service.
GF * Side Clearance: Grills installed near a side wall must allow a minimum clearance of
CERTIFIED 8" (20.32 cm).
e« Access must be provided to remove and empty grease container.
8101P658-60
(11-04-00)