Panasonic WV-CM1420 Operating Instructions Manual page 5

© Video Input Connectors (VIDEO IN A/B) © AC Inlet Socket (AC IN)
For input of composite video signal from an outboard Plug the power cord (supplied as a standard accesso-
device. ry) into this socket and connect it to an AC outlet.
© Video Output Connectors (VIDEO OUT A/B)
The video input signal connected to the Video Input
Connector is looped through to this connector and ter¬
minated automatically.
INSTALLATION
The installation described below should be made by qualified service personnel or system installers.
■ Mounting into the Rack
To install the VW-CM1420 Color Monitor in an EIA rack, use the rack mounting brackets WQ-LM140E (optional) with rack
mounting screws.
1. Turn off the power of the monitor.
2. Remove four screws on both side panels of the WV-CM1420.
These screws are no needed after this.
3. Fix the Rack Angle Brackets by using the four supplied screws (M4x12).
4. Mount the WV-CM1420 onto the rack using eight screws (procured locally).
Cautions:
• Do not block the ventilation opening or slots on the cover to prevent the appliance from overheating.
Always keep the temperature in the rack within 45°C (113*F).
• If the rack is subject to vibration, secure the rear of the unit to the rack using additional rack mounting brackets (procured
locally).
• Leave one space free both above and below the monitor, or install a cooling fan in the rack.
5