FUTABA FP-3PB Instruction Manual page 9

BASIC SETTINGS
MEFET amp adjustment
Do not make these adjustments with the motor connected.
Turn fully clookwise.
Neutral .
Set the throttle trigger to the neutral
adjustment point and the set the neutral point of
the speed control by adjustins the
neutral trimmer until the monitor lamp
goes off. Then turn the neutral
trimmer a small amount from the
point at which the monitor lamp goes
off to ensure a positive neutral point. aca be
Set the throttle trigger to a little
High point before maximum speed, then
adjustment set the high point trimmer so
that the monitor lamp changes T
from green to red. maximum
speed
Adjust the power curve while
Power : running.
curve * More exact adjustment is possible by
. performing power curve adjustment
adjustment together with transmitter throttle
exponential adjustment.
CAUTION
@When using an FET amp, always turn off the battery fail safe function.
®When not running, always disconnect the drive Nicd
battery pack.
HMWith the adjustments made up to this point, now run the vehicle slowly and trim as described
on the next page.