Table of Contents
Advertisement
The procedure below indicates how the output and the display changes with each press.
The active track appears for three seconds on the TV screen. It always appears in the tront panel display.
z
reve
| tite [ame [aris —
pope
Soundtrack 1 (left channel)
1 Press PLAY (pb ).
No message
Soundtrack 2 (right channel)
2 | 2 Press AUDIO MONITOR, =
AUDIO MONITOR.
| 2 PressaUOIOMONITOR, == | ik
Left channe!
Soundirack 1 (left channel)
pees nsoOwoWTONSe | aR | nga | sonara prom
4 Press AUDIO MONITOR again to
Stereo
Soundtrack 1 (left channel)
return to stereo status.
(Both channels)
| Soundtrack 2 (nght channel)
To Switch from Digital to
ANALOG
Press the ANALOG button on the Remote to
Analog Sound ....................
CT}
switch the player
to analog or digital sound.
Digital affords a better quality sound
(Remote)
reproduction. If the LD contains a digital sound
signal, the player automatically sends that
output to the amplifier or receiver. When you
press
the ANALOG button
on the Remote. you
can switch to analog sound. To returm to digital
sound, press the ANALOG button again.
With certain discs there may be a difference in
volume.
Discs with a C™R (CX) Label ....
a)
Discs bearing the CM tabel are recorded with
Cc)
the CX noise reduction system, which gives
lower norse levels and higher dynamic range on
(Remote)
analog sound. The player detects most
C® discs and activates the CX norse reduction
system automatically. Press the Cgg button on
the Remote. "CX ON" will appear on the TV
screen for three seconds. When playing a
C@ disc which does not contain a code to
activate the CX noise reduction system, press
the Ci button. "CX ON" will appear and the
noise reduction system will be activated.
t&
Ta Plaw a t scar Mier
Advertisement
Table of Contents
