Advertisement
TROUBLESHOOTING
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the
points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or your dealer
to carry out repair work.
1. Disc table is not ejected when &
is pressed.
2. Disc table comes out.
3. Remote control does not work.
4. Operation of the remote control
unit causes the TV to operate
improperly.
Power cord is not properly plugged into AC wall
socket.
Power switch is not turned on.
Disc is dirty.
The disc is not properly set on the disc table.
Moisture has condensed on parts in the player.
Disc is warped.
The CONTROL IN terminal on the rear panel is
connected to Pioneer projection monitior or AV
amplifier.
Batteries are weak.
There is an obstacle between the player and
the remote control unit.
Remote control unit is not in a good location for
transmission.
Some TV sets have remote control functions
that operate improperly in response to the
remote control unit of the player.
Abnormal functioning of this unit may be caused by static electricity,
or other external interference. To restore normal operation, turn
the power off and then on again, or unplug the AC power cord and
then plug it in again.
26
<VRB1141>
En
e
Plug in power cord.
Turn on power switch.
Clean disc.
Set the disc properly.
Remove disc and let player stand for 1 to 2
hours until it is dry.
Change the disc.
Aim the remote control unit at the projection
monitor or AV amplifier.
Replace batteries.
Remove the obstacle or shift the remote
control position.
Operate the remote control unit in front of the
player.
Move the TV and the player further apart, or
cover the remote sensor of the TV during disc
playback.
Advertisement
