Advertisement
1. Press PGM.
Display with a CD/CDV
30.12
PLAY
PGM
Total Time
Program
0 0.00
Step-1
Pew
an
F
E
a
m)
i)
2. Select the desired chapters or tracks.
With two-sided, LDs, first specify side A or side B with DISC SIDE
A or B and then enter the number of the desired chapter with the
digit buttons.
Example:
To program chapter 9 on side B, chapter 7 on side A,
and chapter 18 on side B, in that order:
Screen display after programming is completed
A PLAY
Program
Step-4
Programmed
chapters
With single-sided LDs, CDs, and CDV discs, just enter the number of
the desired chapter or track with the digit buttons.
Example: To program CD tracks 9, 7, and 18 in that order:
If you make a mistake during entry:
Press CLEAR and enter the correct number with the digit buttons.
5 0.32
PLAY
Total Time
Program
3.29.
Step-4
Number of programmed
eit Ee
tracks and total play time
Programmed
track
numbers
A pause between tracks/chapters can also be programmed
by
pressing II instead of the digit buttons.
If you make a mistake during entry:
Press CLEAR
on the remote control unit and enter the correct
number with the digit buttons.
24
<VRB1141>
En
LD/CDV/CD
3. Press >.
PLAY
(CT)
To check the program contents
During program playback or in stop mode, press PGM to display the
program contents on the monitor screen. When
PGM is pressed
again, the program contents disappear.
e
You can view the state of programming on the monitor screen.
To modify the program contents
To delete or change a programmed chapter/track or pause:
1. Press PGM.
2. Press kea or >> to place the cursor (œ) on the left side of the
chapter/track or pause to be changed.
. To delete it, press CLEAR. To replace it with another chapter/track,
enter the new chapter/track number with the digit buttons.
Press If to enter a pause.
. Press PGM to complete programming. Pressing > also completes
programming and starts program playback with the new program
contents.
e
Programmed chapter/track being played cannot be erased or
changed.
e
Programmed pause being engaged cannot be erased or
changed.
To clear the program playback
Press CLEAR to return to normal playback.
w
oS
To clear the program contents:
e Open the disc table.
e
Press CLEAR while in stop mode.
NOTES:
e
|f ®
is held depressed during Program Playback, the playback
position will move
to another chapter/track, but when >»
is
released, the next chapter/track in the program will be played. If
a
is held depressed, the playback position returns to the
beginning of the current chapter or track being played, but it will
not go beyond it to a previous chapter or track in the program.
e
During program playback, maa and >» can be used to skip the
programmed chapters/tracks or pause.
Advertisement
