Electrical Connection - Satrap OECOPLAN 122+18 KS Instruction Book

L g pl
frozen food compartment
After changing the outer door opening direction at this
type it is necessary to remount the door of the frozen
Operations and their order can be seen in figure.
• Pull out the bottom pin holding the door of the
frozen food compartment (1).
• Open the door and remove it from the frame
carefully (2).
• Turn the door.
• Take the distance sleeve (3) and the upper pin (4)
out of the door then replace the sleeve (3) to below,
the upper pin (4) to above.
• Unscrew the screw fixing the bolt body and fix it on
the other side with this screw (5).
• Replace the door of the frozen food compartment
and fix it with the bottom pin (1).
In case you do not want to perform the procedures
above, call the nearest brand-mark service.
Technicians will accomplish the refitting expertly for
charge.
Electrical connection
This refrigerator is designed to operate on a
230 V AC (-) 50 Hz supply.
The plug must be put into a socket with protective
contact. If there is no such, it is recommended to
get an electrician to fit an earthed socket in
compliance with standards near the refrigerator.
< < This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.02.73 (Low Voltage Directive)
and subsequent modifications,
- 89/336 EEC of 03.05.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
64
11
-1
S J
r
02112==n
1
é
1
13, ®<1
® , r*.1-=
-
-1
CO