Accessory Parts; Installation Of R32 Refrigerant Air Conditioner - Toshiba RAV-GE6001A8P-T Installation Manual

2

Accessory parts

Part name Q'ty Shape
Installation Manual 1 This manual
Protective bush 1
Guard material for passage
1
part
Rubber Sheet 1
Drain nipple 1
15-EN
1121901101.indd 9
Usage
Hand this directly to the customer.
For protecting wires (pipe cover)
For protecting passage part (pipe cover)
For protecting small lizard and mice.
3

Installation of R32 refrigerant air conditioner

CAUTION
R32 refrigerant air conditioner installation
This air conditioner adopts the HFC refrigerant (R32) which does not destroy ozone layer.
•
Therefore, during installation work, make sure that water, dust, former refrigerant, or refrigerant oil does not
enter the R32 refrigerant air conditioner cycle. To prevent mixing of refrigerant or refrigerant oil, the sizes of
connecting sections of charge port on the main unit and installation tools are different from those of the
conventional refrigerant units.
Accordingly, special tools are required for the R32 or R410A refrigerant units. For connecting pipes, use new
and clean piping materials with high pressure fittings made for the R32 or R410A only, so that water and/or dust
does not enter.
When using existing piping, refer to "16 APPENDIX - [1] Existing piping".
•
Required Tools/Equipment and Precautions for Use
■
Prepare the tools and equipment listed in the following table before starting the installation work.
Newly prepared tools and equipment must be used exclusively.
Legend
: Conventional tools (R32 or R410A)
: Prepared newly (Use for R32 only)
Tools / equipment
Gauge manifold
Vacuuming / charging
refrigerant and operation check
Charging hose
Charging cylinder Can not be used
Gas leak detector Charging refrigerant
Vacuum pump Vacuum drying
Vacuum pump with backflow
Vacuum drying
prevention function
Flare tool Flare machining of pipes
– 8 –
Use How to use tools / equipment
Conventional tools (R410A)
Conventional tools (R410A)
Unusable (Use the electronic refrigerant charging
scale)
Conventional tools (R32 or R410A)
Conventional tools (R32 or R410A)
Usable if the backflow prevention adapter is
installed.
Conventional tools (R32 or R410A)
Conventional tools (R410A)
EN
16-EN
10/1/2562 11:10:11