Advertisement
STEP 2: INSTALLING CORNER FRAMES
1. Rest CORNER FRAME-1 (13) on the left/front corner of the
bolt holes. Insert CARRIAGE BOLT M10x80 (3) from top through the hole at the long side of
platform and place FLAT WASHER M10 (4), SPRING WASHER M10 (5) and HEXA NUT M10 (6)
onto the end of the bolt. Then insert THREE CARRIAGE BOLT M10x120 (10) from top through
the bolt holes at the short side of platform and place FLAT WASHER M10 (4), SPRING WASHER
M10 (5) and HEXA NUT M10 (6) onto the end of the bolt. Fasten but do not tighten hardware.
2. Insert CARRIAGE BOLT M10x60 (9) through the hole from the side of platform and place FLAT
WASHER M10 (4), SPRING WASHER M10 (5) and HEXA NUT M10 (6) onto the end of the bolt.
3. Fasten but do not tighten hardware.
4. Repeat the above procedures for mounting the second CORNER FRAME-1 (13) on the
right/back diagonal corner of the
5. Repeat the above 1-3 steps to install CORNER FRAME-2 (9) on the right/front and left/back
corners of the
BASE PLATFORM ASSY
BASE PLATFORM ASSY
(A).
BASE PLATFORM ASSY (A)
(A).
and align
7
Advertisement
