Advertisement
AFTER USE AND MAINTENANCE
− Only qualified peronnel should make repairs to the work platform. After completing repair
and maintenance, check if the work platform is in good conditions.
− Inspection and maintenance can only be conducted with engine turned off and auxiliary
pressure completely disengaged.
− Lower the work platform to flat ground and let off personnel from the work platform.
− Put on personal protective equipment and apparel.
− Each time after use, clean the work platform thoroughly and remove all debris and dirt.
− Visually inspect if there is any parts damaged or deformed, repair and replace if necessary.
− Check if there is any loosen or damaged hardware, tighten or replace hardware is necessary.
− The minimum torque for tightening hardware are shown below:
* M10X80: 18 lbf.ft (24 Nm)
* M16X45: 148 lbf.ft (200 Nm)
* M16X70: 74 lbf.ft (100 Nm)
* M8X20: 10 lbf.ft (13.5 Nm)
* M8X35: 10 lbf.ft (13.5 Nm)
* M10X120: 18 lbs.ft (24 Nm)
* M10X60: 18 lbs.ft (24 Nm)
* M10X65: 18 lbs.ft (24 Nm)
* M10X70: 18 lbs.ft (24 Nm)
* M10X80: 18 lbs.ft (24 Nm)
− When the work platform is dry, check
places where paint is scratched or worn
and repaint if necessary. Apply antirust oil
to surface where necessary.
− Store the work platform in shed and dry
place.
SPECIFICATIONS
Overall Dimensions (L x W x H):
116" x 56.3" x 48.3"
Product Weight: 855 LB
Load Capacity: 1700 LB
Fork Channel: 6.25" x 2.5"
Handrail Height: 42"
Material: Steel
Center of gravity to vertical member of fork: 27.56"
15
Advertisement
