Rainfresh CORO 00N Installation And Operating Instructions

INSTALLATION AND OPERATING INSTRUCTIONS FOR
COMBI-OVEN WATER FILTRATION SYSTEM
MODEL CORO_00N
INSTALLATION CAUTIONS
Installation must conform to all local and state plumbing codes and regulations.

Do not use with water that is microbiologically unsafe or of unknown quality without adequate

disinfection before or after the system.
Do not exceed Maximum Pressure = 100 psi (690 kPa). If water pressure surges, or will at any time

exceed the 100 psi maximum, a pressure regulator must be installed before the filter (recommended
regulator setting is 75 psi or less) along with a water hammer arrestor to prevent potentially
damaging shocks caused by water hammer.
Connect system to cold water supply only. Water temperature should not exceed 100⁰F/28⁰C. Do

not subject the system to freezing temperatures
Do not install system in direct sunlight or where system is exposed to harsh chemicals or may be

subjected to being struck by moving equipment, carts, mops or any other item that may cause
damage.
ALLOW a minimum of 5" under the unit to allow for filter replacement.

Do not run any tubing under or touching the oven

Ensure that any part of the tubing does not come into contact with any heat source

SYSTEM SPECIFICATIONS
Maximum Pressure
Maximum Temperature
Connections
Storage tank capacity
FEED WATER QUALITY
Water hardness
Iron
Manganese
Turbidity
Oil, gases & bacteria
SYSTEM DIMENSIONS
Model
CORO_00N
OPENING THE PACKAGE
The CORO system includes the following:
The main wall-mount unit

Storage tank

6 feet of 3/8" poly tubing

18 feet of ¼" poly tubing

Wall mounting washer strip and mounting screws

: 100 psi/8.6 bar
: 100°F (38⁰C), Min.: 35⁰F (2⁰C)
: Inlet - 3/8" tube ; Outlet, Drain & Tank – ¼" tube
: 3.2 US gal (max) at 60 psi
: Max 7 GPG
: < 0.3 PPM
: < 0.05 PPM
: 1 NTU max
: None
Unit Width (Inch)
16.5"
Unit Height (Inch)
22.5"
Unit Depth (Inch)
6"
1