Table of Contents
Advertisement
CGFE Greensand Filter
Installation & Operation Manual
(Please save for future reference)
Thank you for purchasing one of our ENVIROGARD / Rainfresh products. We are committed to
If you have any problems, don't go back to the store- please contact us !
Help Line : 1-800-667-8072 (Monday to Friday 8:30 AM to 5:00 PM EST)
................................................
.................................................
ensuring that you are totally satisfied.
Most issues can be resolved over the phone.
TABLE OF CONTENTS
................................
....................
....................................
..................
..........................
........................
...................
........................
.........................
.........................
..................
....................
........................................
...........................................
......................................
................
Certified by IAPMO R&T against CSA B483.1
www.rainfresh.ca
2
2
2
3
3
3
4
5
7
7
8
9
10
10
11
12
13
14
Advertisement
Table of Contents
Related Manuals for Rainfresh CGFE948
Summary of Contents for Rainfresh CGFE948
-
Page 1: Table Of Contents
Installation & Operation Manual (Please save for future reference) Thank you for purchasing one of our ENVIROGARD / Rainfresh products. We are committed to ensuring that you are totally satisfied. If you have any problems, don’t go back to the store– please contact us ! Most issues can be resolved over the phone. -
Page 2: System Specifications
This system does not kill or remove bacteria or any other pathogenic microorganisms. To continuously disinfect all the water in your house, we recommend that you install a Rainfresh UV system. Call Rainfresh for details. For use on cold water only. -
Page 3: Installation
Use only lead-free solder and flux. DO NOT over-tighten metal fittings on to unit connections. You will need POT-PERM (Potassium Permanganate) with this unit (included with model CGFE948). NOTE: After the first 3 or 4 days of use, this unit will not work without POT-PERM in the chemical tank. -
Page 4: Installation Location
Unpack the unit and place it at the location where you intend to install it. Stand back and look at the filter to make sure it is standing straight up and not tilted to one side. Sometimes during shipment, the bottom of the tank will get knocked out of alignment and you will need to straighten it out before starting installation. -
Page 5: Plumbing The Filter Unit
Water Fig 3 Fig 4 Plumbing in your CGFE Greensand Filter Turn the power off to the well pump then shut off the main water shut off valve which should be located after the pressure tank. If your hot water tank is electric, turn off the power to it to avoid damage to the element in the tank. Open a faucet closest to the pressure tank, but after the main shut-off valve to de-pressurize the lines. - Page 6 PERM jug and label. Pour the entire 5 lb jug of POT PERM into the chemical tank (included with model CGFE948). The powder stays above the felt pad while the water/Pot Perm solution stays below it. Typically, five pounds of POT PERM should last three to four months or more before refilling with POT PERM powder is required.
-
Page 7: Start-Up And Programming
(E) START UP & PROGRAMMING The control valve is controlled with simple, user-friendly electronics displayed on an LCD screen. When power is first supplied, the valve electronics may take up to a minute to initialize. During this time the screen may show “INTIALIZING WAIT PLEASE”. -
Page 8: Basic Programming
(II) BASIC PROGRAMMING TIME OF DAY TIME OF DAY JUN/21/2020 : 27 PM 05:27 PM : 27 PM 1. Press SETTINGS for 3 sec. 3. Press SETTINGS again and 4. Press DOWN key to 2. After 3 seconds the display the hour value becomes change the hour value to will beep confirming unlock... -
Page 9: Advanced Programming
(III) ADVANCED PROGRAMMING In the advanced programming, you can change individual regeneration cycle times. DO NOT change these without confirming with Rainfresh technical support. By changing these values your unit can malfunction. VALVE MODE VALVE MODE BACKWASH... -
Page 10: Manual Regeneration
REFILL LOCK VALUE PROGRAMMING MINUTES UNLOCK COMPLETE Press DOWN key to Press REGEN button to Display will briefly show either LOCK your settings or advance to “REFILL”. Leave at PROGRAMMING COMPLETE & leave them unlocked. Press default setting. Press REGEN go to home screen. -
Page 11: Maintenance
Check the POT PERM level once a month and add as required. If you find that the water level is much higher than the felt pad, please call Rainfresh customer care. POT PERM can be ordered from the same retailer... -
Page 12: Troubleshooting
(H) TROUBLESHOOTING Please review the following troubleshooting guide before calling customer service. If you are unable to resolve the problem using the guide below, please call customer service at 1800 667 8072 (Mon to Fri 8:30 AM to 5 PM EST) ... -
Page 13: Exploded Diagram & Parts List
PARTS LIST... -
Page 14: Warranty
Canada Envirogard Products Limited 446 Major Mackenzie Drive East, Richmond Hill, ON L4C 1J2, Canada Tel : (905) 884 9388 Helpline: 1800 667 8072 Web: www.rainfresh.ca © COPYRIGHT . ENVIROGARD PRODUCTS LIMITED 2020 . ALL RIGHTS RESERVED...