Yamaha DT125E 1977 Owner's Manual page 40

2. Remove the brake adjuster and brake rod
from the brake arm.
3. Remove the cotter pin from the axle nut
and loosen the axle nut.
4. Remove the link clip and master link and
remove the chain.
5. Remove the cotter pins (left and right).
Then remove the clevis pins.
6. Pull the wheel backward, remove the rear
wheel assembly.
1. Cotter pin 2. Plain washer 3. Clevis pin
Rear wheel installation
The rear wheel can be reassembled by
reversing the disassembly procedure. Take
care of the following points.
1. When connecting the chain, make certain
closed end of master link clip is facing
direction of rotation.